安装 · NC500 · 机械

全部步骤完成后再撕除蓝色保护膜。

NC500 安装

机械安装

共 14 步，从调平到最终外观检查。

← NC500 安装与调试指南

Packing list

Verify main unit, dust bin, pneumatic cylinder, covers, motor, leveling feet, and side panel after unboxing.

Steps 1–4 — Level, cylinder, press plate, wiring

Level the host, mount the pneumatic cylinder, adjust three white press-plate screws, and connect cables/air lines.

NC500 pneumatic cylinder — Fig. 2 — Pneumatic cylinder

NC500 press plate screws — Fig. 3 — Press plate height

NC500 cable connections — Fig. 4 — Cables & air lines

Steps 5–8 — Panel, bellows, dust, side cover

Install control panel cantilever, bellows cover (green alignment marks), dust collection unit, and side panel.

NC500 panel cantilever — Fig. 5 — Panel cantilever

NC500 bellows cover — Fig. 6 — Bellows cover

NC500 dust collection — Fig. 7 — Dust collection

Steps 9–14 — Feed mechanism through final check

Complete press plate/feed mechanism, internal adjustments, feed motor, ball screw/guides, final bolt check, and front appearance.

Manual press plate stroke must be jam-free before energising
Ball screw parallel to linear guides; full travel smooth when rotating coupling
Remove all blue protective film before first run

NC500 press plate feed — Fig. 9 — Press plate & feed

NC500 ratchet adjustment — Fig. 10 — Internal adjustment

NC500 sensor adjustment — Fig. 11 — Sensor adjustment

NC500 ball screw guides — Fig. 13 — Ball screw & guides

NC500 final tightening — Fig. 14 — Final tightening

NC500 complete front view — Fig. 15 — Complete machine

Mechanical installation FAQ

When do I remove the blue protective film?

After all installation and debugging steps are complete — on the cylinder, press plate, and crossbeam — before trial run.

Why adjust three press-plate screws equally?

Uneven adjustment tilts the press plate and causes inconsistent clamping across the work surface.

下一步：面板与试机

继续阅读

完整手册

Steps 9–14 — Feed mechanism through final check

Complete press plate/feed mechanism, internal adjustments, feed motor, ball screw/guides, final bolt check, and front appearance.

Manual press plate stroke must be jam-free before energising

Ball screw parallel to linear guides; full travel smooth when rotating coupling

Remove all blue protective film before first run

Fig. 9 — Press plate & feed

Fig. 10 — Internal adjustment

Fig. 11 — Sensor adjustment

Fig. 12 — Feed motor

Fig. 13 — Ball screw & guides

Fig. 14 — Final tightening

Fig. 15 — Complete machine

Mechanical installation FAQ

When do I remove the blue protective film?

After all installation and debugging steps are complete — on the cylinder, press plate, and crossbeam — before trial run.

Why adjust three press-plate screws equally?

Uneven adjustment tilts the press plate and causes inconsistent clamping across the work surface.

Packing list

Steps 1–4 — Level, cylinder, press plate, wiring

Steps 5–8 — Panel, bellows, dust, side cover

Steps 9–14 — Feed mechanism through final check

Mechanical installation FAQ

继续阅读

完整手册

相关产品

探索新框源

每周装裱设备行业洞察

Packing list

Steps 1–4 — Level, cylinder, press plate, wiring

Steps 5–8 — Panel, bellows, dust, side cover

Steps 9–14 — Feed mechanism through final check

Mechanical installation FAQ

继续阅读

完整手册

相关产品

探索新框源

每周装裱设备行业洞察