安装 · NN300 · 试机

批量生产前连续试制 3–5 件并检验四角质量。

NN300 安装

试机与验收

首次启动前必须在 IO 监控屏启用缺料与缺钉检测。

← NN300 安装与调试指南

Trial run procedure

Load one moulding display-face up for a single-piece trial before batch production.

Material-Out Detection and Nail-Out Detection must be enabled on the IO Monitor screen before start.

Enter IO Monitor via bottom navigation
Confirm Material-Out and Nail-Out detections enabled
Press green Start on HMI
Inspect nailing quality and four-corner joints

NN300 IO Monitor detections — Fig. 15 — IO Monitor

NN300 Start and E-stop — Fig. 16 — Start & E-stop

Optional — frame collector & conveyor

Skip this section if the collector/conveyor option was not purchased.

Collector width clearance: 3–5 mm vs finished frame width
Length clearance: approx. 5 mm after magazine window adjustment
Verify red-line defect sensor stops the line (trigger once during trial)

NN300 collector width — Fig. 18 — [Optional] Collector width

NN300 collector lift platform — Fig. 19 — [Optional] Lift platform

NN300 conveyor connection — Fig. 20 — [Optional] Conveyor

NN300 red-line sensor — Fig. 21 — [Optional] Red-line sensor

验收 FAQ

What is the acceptance criterion for trial pieces?

Four corners joint well with no missed or misaligned nails. Run 3–5 consecutive acceptable pieces before full production.

What if the machine dry-fires?

Stop immediately. Confirm Material-Out Detection is enabled and magazines are loaded before restarting.

申请 NN300 调试支持

继续阅读

完整手册

安装 · NN300 · 试机

批量生产前连续试制 3–5 件并检验四角质量。

NN300 安装

试机与验收

首次启动前必须在 IO 监控屏启用缺料与缺钉检测。

← NN300 安装与调试指南

Trial run procedure

Load one moulding display-face up for a single-piece trial before batch production.

Material-Out Detection and Nail-Out Detection must be enabled on the IO Monitor screen before start.

Enter IO Monitor via bottom navigation
Confirm Material-Out and Nail-Out detections enabled
Press green Start on HMI
Inspect nailing quality and four-corner joints

Optional — frame collector & conveyor

Skip this section if the collector/conveyor option was not purchased.

Collector width clearance: 3–5 mm vs finished frame width
Length clearance: approx. 5 mm after magazine window adjustment
Verify red-line defect sensor stops the line (trigger once during trial)

验收 FAQ

What is the acceptance criterion for trial pieces?

Four corners joint well with no missed or misaligned nails. Run 3–5 consecutive acceptable pieces before full production.

What if the machine dry-fires?

Stop immediately. Confirm Material-Out Detection is enabled and magazines are loaded before restarting.

申请 NN300 调试支持

Trial run procedure

Optional — frame collector & conveyor

验收 FAQ

继续阅读

完整手册

相关产品

探索新框源

每周装裱设备行业洞察

Trial run procedure

Optional — frame collector & conveyor

验收 FAQ

继续阅读

完整手册

相关产品

探索新框源

每周装裱设备行业洞察